Hw-module Slot R0 Reload



Cheat Tables for yuzu. Contribute to zarroboogs/yuzu-ct development by creating an account on GitHub. New players only. One offer per player. Max Hw Module Slot Reload bonus bet £5. 1st Dep offer is 100% up to £250 + 100 Bonus spins on Hw Module Slot Reload Aloha Cluster Pays. Spins expire after 10 days, funds after 30 days. Bonus funds separate to Cash. Wager Req of 35x Deposit + Bonus apply. The hw-module slot stop command in EXEC mode automatically stops traffic on the interfaces and deactivates them along with the SPA in preparation for OIR. In similar fashion, you do not need to independently restart any interfaces on a SPA after OIR of a SPA or SIP. Enter the show facility-alarm status command. Every casino that Hw Module Slot F0 Reload makes it to our list is synonymous with fair play, integrity, reliability, and security. Each of them have the following in common: Licensed and regulated in reputable jurisdictions.

Can anyone comment on RSP redundancy with SSO mode?
I have a test 7507 with rsp-k4pv-mz.120-32.S8.bin on both RSP2s. I've done

Hw-module Slot R0 Reloadable


this: Hw-module slot r0 reloading
service single-slot-reload-enable
redundancy
no keepalive-enable
mode sso
And it doesn't seem to ever sync the slave
ranttest#show red
Redundant System Information :
------------------------------
Available system uptime = 14 minutes, 49 seconds
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hw-module slot r0 reloadable Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = hsa
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 2
Current Software state = ACTIVE

Hw-module Slot R0 Reloader


Uptime in current state = 13 minutes, 24 seconds
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(32)S8, RELEASE SOFTWARE
(fc1) Reloading
Technical Support: http://www.cisco.com/techsupportHw-module Slot R0 Reload
Copyright (c) 1986-2007 by cisco Systems, Inc.
SlotCompiled Mon 20-Aug-07 16:34 by leccese
BOOT =

Hw-module Slot R0 Reloading

CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Peer (slot: 3) information is not available because it is in 'DISABLED'
state
ranttest#redundancy force-switchover
Cannot perform switchover until the standby is fully initialized.

Hw-module Slot R0 Reloaded


The box is up, its got two OSPF adjacencies, maybe a hundred routes - its
not doing anything fancy, so I'm kind of stuck here. The production target
is 7507s /w RSP4s, the same OSPF, and about 180k routes via BGP. Any idea
what might be wrong here?
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/